You need a snow thrower that works. Whether it's a starting issue or a clogged chute, don't fear – follow this guide to Troubleshoot your Troy-Bilt snow thrower.
Your engine might take a little revving to get started. Start by emptying out any remaining fuel that's still in the tank from last season. Now fill your tank with fresh, clean fuel.
Remove the dipstick to check on your oil levels. If you use your snow thrower with an improper amount of oil, you run the risk of damaging your engine. Also, make sure you set the choke and push the primer bulb a couple of times before your first pull. If you have a push-button electric start model, you can skip the pull-starting step.
Finally, check to see if your spark plug is unplugged, covered in build up, or if it's corroded. If you discover any of these issues, you'll need to clean and/or replace your spark plug.
Now onto the chute. Some snow throwers from Troy-Bilt are designed with an adjustable chute so you can control and change the direction and pitch of snow as you're clearing. With these models, heavy, wet snow or foreign objects might clog your chute. If this happens to you, have no fear! You can fix it by following these steps:
Release the auger and drive controls. Shut off the engine, but remain behind the handles until all of the moving parts on your snow thrower have stopped. Now, use your clean-out tool (using the shovel-shaped end) to break down and remove the ice or snow that's formed in and near the chute assembly. For most Troy-Bilt models, you'll find your clean-out tool on the rear of the auger housing.
When you've successfully cleared out the chute, refasten the clean-out too to the mounting clip. Reinsert the ignition key and start your snow thrower back up. Stand in the operating position and engage the auger control for a few moments to clear any and all remaining ice and snow from the chute assembly. You're ready to clear more snow!
.svg)
.png)
